Repair information 4-77
4024-XXX
Media eject clutch removal
1. Remove the rear upper cover. See “Rear upper cover removal” on page 4-24.
2. Disconnect the connector from the sensor (media eject shaft HP) (A).
3. Release the harness from the clamp.
4. Disconnect the connector from the media eject clutch (B).
5. Release the harness from the clamp.
6. Release the hook securing the media eject clutch actuator (C) to the media eject clutch (B).
7. Remove the screw securing the spring clamp (D) to the finisher.
8. Remove the spring clamp (D).
9. Remove the media eject clutch actuator (C).
10. Remove the media eject clutch (B).
Installation note: Make sure the hook on the media eject clutch is placed in the notch of the bracket.
A
D
C
B
Notch
Clamp
B
Connector
Connector
To Next Page
Loading...
