Repair information 4-43
4024-XXX
Punch carriage shift motor assembly removal
1. Open the finisher front door assembly.
2. Remove the rear upper cover. See “Rear upper cover removal” on page 4-24.
3. Remove the punch carriage assembly. See “Punch carriage assembly removal” on page 4-41.
4. Remove the two screws securing the cover (A) to the punch carriage assembly (B).
5. Remove the cover (A).
6. Remove the two screws securing the punch carriage shift motor assembly (C) to the punch unit
assembly (B).
7. Remove the punch carriage shift motor assembly (C).
To Next Page
Loading...
