4-42 Finisher Service Manual
4024-XXX
11. Remove the two screws on the front securing the punch carriage assembly (B) to the finisher.
12. While moving the belt (buffer/transport) (E) to the left as shown, pull the punch carriage assembly (B)
gently out of the rear of the finisher.
Warning: Do not force the punch carriage assembly (B) out of the finisher. Be sure to hold the unit firmly
to avoid dropping it.
Replacement notes:
• Do not force the punch unit into the finisher.
• Be sure to hold the punch carriage assembly firmly to avoid dropping it.
• Make sure all harnesses are properly clamped.
• Make sure the punch carriage assembly is able to shift back and forth completely without binding the
harnesses.
• Make sure the harnesses do not come into contact with any rotating mechanisms.
To Next Page
Loading...
