Lexmark W850 - Sensor (Diverter Gate) Removal

4-110 Finisher Service Manual
4024-XXX
Sensor (diverter gate) removal
1. Open the finisher front door assembly.
2. Remove the rear upper cover. See “Rear upper cover removal” on page 4-24.
3. Remove the top cover. See “Top cover removal” on page 4-19.
4. Remove the left lower cover. See “Left lower cover removal” on page 4-28.
5. Remove the left upper cover. See “Left upper cover removal” on page 4-29.
6. Remove the punch carriage assembly. See “Punch carriage assembly removal” on page 4-41.
7. Remove the two screws securing the bracket (A) to the finisher.
8. Remove the bracket (A).
9. Disconnect the connector from the sensor (diverter gate) (B).
10. Remove the screw securing the sensor (diverter gate) (B) to the bracket (A).
11. Remove the sensor (diverter gate) (B).
B
Left
A
Connector