Lexmark W850 - Media Eject Shaft Assembly Removal

4-74 Finisher Service Manual
4024-XXX
Media eject shaft assembly removal
1. Remove the finisher front door assembly. See “Finisher front door assembly removal” on page 4-27.
2. Remove the rear upper cover. See “Rear upper cover removal” on page 4-24.
3. Move the slip clutch gear 24T (A) toward the rear as shown to disengage the stacker bin (B).
4. Move the stacker bin down as shown to its lowest position after being disengaged.
Note: Make sure the stacker bin is at its lowest position before continuing.
5. Remove the upper media bin assembly. See “Stacker media bin assembly removal” on page 4-22.
6. Remove the four screws securing the right panel (C) to the finisher.
7. Remove the media eject motor assembly. See “Media eject motor assembly removal” on page 4-78.
8. Release the hook of the media eject shaft gear 39T (D) from the media eject shaft assembly (E).
9. Remove the media eject shaft gear 39T (D).
10. Remove the 6 mm bushing (F).
11. Remove the e-clip with a prying tool securing the media eject shaft assembly (E) to the rear of the finisher.
12. Remove the 8 mm bushing (G).
13. Remove the two e-clips securing the media eject shaft assembly (E) to the front of the finisher.
14. Remove the 6 mm bushing (F) and the 8 mm bushing (G).
A
Rear
C
B