Repair information 4-67
4024-XXX
Sensor (media eject clamp HP) removal
1. Remove the rear upper cover. See “Rear upper cover removal” on page 4-24.
2. Remove the upper media bin assembly. See “Upper media bin assembly removal” on page 4-20.
3. Remove the two media eject unit springs attached to the media eject unit assembly by pushing them
downward.
4. Remove the media eject clamp motor assembly. See “Media eject clamp motor assembly removal” on
page 4-66.
5. Release the hooks of the sensor (media eject clamp HP) (A) from the bracket (B).
6. Remove the sensor (media eject clamp HP) (A).
To Next Page
Loading...
