2-42 Finisher Service Manual
4024-XXX
285.00 Finisher eject set jam
3 Check the drive motor (exit) for correct operation.
Check the above motor by opening the finisher front
door assembly and then closing it.
Does the motor (exit) rotate normally?
Go to step 5. Go to step 4.
4 Check the drive motor (exit) connection.
Is the above motor connected properly?
Replace the drive
motor (exit). Go
to “Drive motor
(exit) assembly
and belt (exit)
removal” on
page 4-113.
Replace the
connection.
5 Perform a teat print.
Does the error still occur?
Replace the
finisher controller
card assembly.
Go to “Finisher
controller card
assembly
removal” on
page 4-118.
Problem solved.
Step Check Yes No
1 Check the media path.
Check the media eject shaft by turning it with your
fingers.
Is the media eject shaft assembly installed correctly,
meaning does it rotate smoothly?
Go to step 2. Clean or replace
the media eject
shaft assembly
and clean the
media path.
2 Check the media eject clamp motor by opening the
finisher front door assembly, and then closing it.
Does the media eject clamp motor rotate normally?
Go to step 4. Go to step 3.
3 Check the media eject motor connection.
Is the above motor connected properly?
Disconnect then
reconnect the
connector P8304
on the finisher
controller card
assembly.
Perform a test
print, if the error
still occurs
replace the
media eject
motor assembly.
Replace the
connection.
4 Check the compiler media in actuator for correct
operation.
Is the actuator operating correctly?
Go to step 5. Reinstall the
compiler media in
actuator. Go to
“Sensor
(compiler media
in) removal” on
page 4-73.
Step Check Yes No
To Next Page
Loading...
