Lexmark W850 - Sensor (Punch Carriage Shift HP) Removal

Repair information 4-51
4024-XXX
Sensor (punch carriage shift HP) removal
1. Open the finisher front door assembly.
2. Remove the rear upper cover. See “Rear upper cover removal” on page 4-24.
3. Remove the punch carriage assembly. See “Punch carriage assembly removal” on page 4-41.
4. Remove the one screw securing the bracket (A) to the punch carriage unit (B).
5. Release the hooks securing the sensor (punch carriage shift HP) (C) to the bracket (A).
6. Remove the sensor (punch carriage shift HP) (C).
A
B
C