Lexmark W850 - Sub Paddle Drive Shaft Assembly Removal

4-64 Finisher Service Manual
4024-XXX
Sub paddle drive shaft assembly removal
1. Open the finisher front door assembly.
2. Remove the rear upper cover. See “Rear upper cover removal” on page 4-24.
3. Remove the media eject unit assembly. See “Media eject unit assembly removal” on page 4-59.
4. Loosen the screw securing the knob (A) to the sub paddle drive shaft assembly (B) on the front of the
finisher.
5. Remove the knob (A).
6. Remove the one e-clip securing the sub paddle drive shaft assembly (B).
7. Remove the bushing (C).
B
C
A
E-clip
Screw
Front