Lexmark W850 - Media Diverter Gate Solenoid Removal

4-102 Finisher Service Manual
4024-XXX
Media diverter gate solenoid removal
1. Open the finisher front door assembly.
2. Remove the rear upper cover. See “Rear upper cover removal” on page 4-24.
3. Disconnect the connector from the media diverter gate solenoid (A).
4. Release the harness from the clamp.
5. Remove the two screws securing the bracket (B) to the finisher.
Note: The bracket should not be removed from the finisher, it should be gently moved to provide better
access to the media diverter gate solenoid mounting screws.
6. Remove the two screws securing the media diverter gate solenoid to the finisher.
7. Remove the media diverter gate solenoid.
Note: The link (C) may remain inserted into the finisher.
8. Remove the link.
Note: When the link is removed, the media diverter gate may become detached. See “Media diverter
gate removal” on page 4-91.
)
A
C
B
Clamp
C
Clamp
Connector