Lexmark W850 - Page 253

Repair information 4-101
4024-XXX
5. Remove the two screws securing the bracket (D) to the finisher.
6. Remove the bracket (D).
7. Remove the two screws securing the bracket (D) to the drive motor (entrance/paddle) (C).
8. Remove the drive motor (entrance/paddle) (C).
9. Remove the belt (entrance/paddle) (B).
Replacement notes:
• The tension of the belt (entrance/paddle) (B) is automatically adjusted by the force of the spring attached to
the belt tensioner bracket (A).
• Tighten the two screws in the order shown.
D
C
Connector