4-30 Finisher Service Manual
4024-XXX
Carriage lift belt left removal
1. Remove the rear upper cover. See “Rear upper cover removal” on page 4-24.
2. Remove the finisher front door assembly. See “Finisher front door assembly removal” on page 4-27.
3. Move the slip clutch gear 24T (A) toward the rear to disengage the stacker bin (B).
4. Move the stacker bin (B) down to its lowest position after being disengaged.
Note: Make sure the stacker bin is at its lowest position before continuing.
To Next Page
Loading...
