Lexmark W850 - Punch Media Stop Assembly Removal

4-46 Finisher Service Manual
4024-XXX
Punch media stop assembly removal
1. Open the finisher front door assembly.
2. Remove the rear upper cover. See “Rear upper cover removal” on page 4-24.
3. Remove the punch carriage assembly. See “Punch carriage assembly removal” on page 4-41.
4. Remove the punch unit assembly. See “Punch unit assembly removal” on page 4-45.
5. Remove the three screws securing the three punch media stop assemblies (A) to the punch unit
assembly (B).
6. Remove the three punch media stop assemblies (D).