Lexmark W850 - Media Eject Motor Assembly Removal

4-78 Finisher Service Manual
4024-XXX
Media eject motor assembly removal
1. Remove the rear upper cover. See “Rear upper cover removal” on page 4-24.
2. Remove the media eject clutch. See “Media eject clutch removal” on page 4-77.
3. Disconnect the connector from the media eject motor assembly (A).
4. Disconnect the connector from the sensor (media bin level 2) (B).
5. Remove the three screws securing the media eject motor assembly (A).
6. Remove the media eject motor assembly (A).
7. Remove any remaining harnesses from the clamps.
A
Rear
Connector