Repair information 4-13
4024-XXX
Bridge unit drive motor assembly removal
1. Remove the bridge unit rear cover. See “Bridge unit rear cover removal” on page 4-6.
2. Remove the bridge unit drive belt. See “Bridge unit drive belt and bridge unit drive pulley removal” on
page 4-8.
3. Disconnect the connector from the bridge unit drive motor (A).
4. Release the harness from the clamp.
5. Open the bridge unit top cover assembly.
6. Remove the two screws securing the cover (B) from the bridge unit assembly (C).
7. Remove the cover (B).
8. Remove the two screws securing the bridge unit drive motor (A) to the bridge unit assembly (C).
9. Remove the bridge unit drive motor (A).
To Next Page
Loading...
