Diagnostic information 2-67
4024-XXX
2 Check the sensor (stacker bin no media) for correct
operation.
Perform the sensor (stacker bin no media) test.
1. Enter Diagnostics mode.
2. Select FINISHER TESTS.
3. Select Sensor Tests.
4. Select Bin Level.
5. Select Stacker bin no media.
Does the display on the operator panel change every
time the sensing area of the sensor (stacker bin no
media) is blocked?
Go to step 4. Go to step 3.
3 Is the sensor (stacker bin no media) connected
properly?
Replace the
sensor (stacker
bin no media).
Replace the
connection.
4 Check the sensor (stacker bin level 1) for correct
operation.
Perform the sensor (stacker bin level 1) test.
1. Enter Diagnostics mode.
2. Select FINISHER TESTS.
3. Select Sensor Tests.
4. Select Bin Level.
5. Select Stacker bin level1.
Does the display on the operator panel change every
time the sensing area of the sensor (stacker bin level 1)
is blocked by a multi page document or your finger?
Go to step 6. Go to step 5.
5 Is the sensor (stacker bin level 1) connected properly? Replace the
sensor (stacker
bin level 1). Go to
“Sensor
(stacker bin
level 1)
removal” on
page 4-34.
Replace the
connection.
6 Check the sensor (stacker bin level 2) for correct
operation.
Perform the sensor (stacker bin level 2) test.
1. Enter Diagnostics mode.
2. Select FINISHER TESTS.
3. Select Sensor Tests.
4. Select Bin Level.
5. Select Stacker bin level2.
Does the display on the operator panel change every
time the sensing area of the sensor (stacker bin level
rear) is blocked by a multi page document or your
finger?
Go to step 8. Go to step 7.
7 Is the sensor (stacker bin level 2) connected properly? Replace the
sensor (stacker
bin level 2). Go to
“Sensor
(stacker bin
level 2)
removal” on
page 4-34.
Replace the
connection.
Step Check Yes No
To Next Page
Loading...
