2-44 Finisher Service Manual
4024-XXX
4 Check the sensor (compiler media in) connection.
Is the above sensor connected properly?
Replace the
sensor (compiler
media in). Go to
“Sensor
(compiler media
in) removal” on
page 4-73.
Replace the
connection.
5 Check the media eject motor assembly by opening the
finisher front door assembly and then closing it.
Does the media eject motor assembly rotate normally?
Go to step 7. Go to step 6.
6 Check the media eject motor assembly connection.
Are the connections of the main drive cable assembly
correctly connected?
Replace the
media eject
motor assembly.
Go to “Media
eject motor
assembly
removal” on
page 4-78.
Replace the
connection.
7 Perform a test print.
Does the error still occur?
Replace the
finisher controller
card assembly.
Go to “Finisher
controller card
assembly
removal” on
page 4-118.
Problem solved.
Step Check Yes No
To Next Page
Loading...
