Lexmark W850 - Page 259

Repair information 4-107
4024-XXX
10. Remove the bracket (C).
11. Release the hook from the upper media exit roll drive gear 20T(D).
12. Remove the upper media exit roll drive gear 20T.
13. Remove the 6 mm bushing.
14. Remove the e-clip with a prying tool securing the upper media exit roll assembly (F) to the front of the
finisher.
15. Remove the 6 mm bushing (E).
16. Move the upper media exit roll assembly frontward and outward in the direction of the arrow.
17. Remove the upper media exit roll assembly (F).
Note: When removing the upper media exit roll assembly (F), do not touch the rubber surface.
Replacement notes:
• Maker sure the flat spot of the upper media exit roll assembly (F) is installed to the rear.
• When replacing the upper media exit roll assembly (F), do not touch the rubber surface.
B
C
Front
F
E-clip
E
Rear
D
F
E