Lexmark W850 - Page 26

2-4 Finisher Service Manual
4024-XXX
283.00
Paper jam
Check areas G, G4
Sensor (buffer path) on
jam A
Sensor (buffer path) is not turned on within the
specified time after the sensor (finisher media entrance
is turned on.
Go to “283.00 Sensor (buffer path) on jam A” on
page 2-23.
283.01
Paper jam
Check area G2
Sensor (buffer path) on
jam B
Sensor (buffer path) is not turned on within the
specified time after the sensor (finisher media entrance
is turned on.
At this time, the sensor (diverter gate) is turned on.
Go to “283.01 Sensor (buffer path) on jam B” on
page 2-25.
283.02
Paper jam
Check areas G2, G3
Sensor (buffer path)
Static jam A
Paper remains on the sensor (finisher buffer path).
At this time, both sensor (diverter gate) and sensor
(finisher media exit) are turned on.
Go to “283.02 Sensor (buffer path) static jam A” on
page 2-28.
283.03
Paper jam
Check area G2
Sensor (buffer path)
Static jam B
Paper remains on the sensor (finisher buffer path).
At this time, the sensor (diverter gate) is on state, but
the sensor (finisher media entrance) is turned off.
Go to “283.03 Sensor (buffer path) static jam B” on
page 2-29.
283.04
Paper jam
Check area G4
Sensor (buffer path)
Static jam C
Paper remains on the sensor (finisher buffer path).
At this time, the sensor (diverter gate) is turned off.
Go to “283.04 Sensor (buffer path) static jam C” on
page 2-30.
284.00
Paper jam
Check area F
Sensor (lower media
exit) off jam A
Sensor (lower media exit) is not turned off within the
specified time after the finisher sensor (lower media
exit) is turned on.
At this time, the sensor (bridge unit media exit) is
turned on.
Go to “284.00 Sensor (lower media exit) off jam A.”
on page 2-31.
284.01
Paper jam
Check area F
Sensor (lower media
exit) on jam A
Sensor (buffer path) is not turned on within the
specified time after the sensor (finisher media
entrance) is turned on.
At this time the sensor (bridge unit media exit) is turned
on.
Go to “284.01 Sensor (lower media exit) on jam A”
on page 2-32.
284.02
Paper jam
Check areas G2, G3
Sensor (lower media
exit) on jam B
Sensor (buffer path) is not turned on within the
specified time after the sensor (bridge unit media
entrance) is turned on.
At this time, the sensor (finisher media entrance) is
turned on.
Go to
“284.02 Sensor (lower media exit) on jam B”
on page 2-35.
284.03
Paper jam
Check area G2
Sensor (lower media
exit) on jam C
Finisher sensor (lower media exit) not turned on within
the specified time after the sensor (buffer path) is
turned on.
Go to “284.03 Sensor (lower media exit) on jam C”
on page 2-38.