2-24 Finisher Service Manual
4024-XXX
4 Are the four buffer pinch guide pinch rolls attached on
the lower pinch guide assembly installed correctly?
Go to step 5. Clean or replace
the appropriate
rolls and clean
the media path.
5 Check the sensor (diverter gate) for correct operation.
Perform the sensor (diverter gate) test.
1. Enter Diagnostics mode.
2. Select FINISHER TESTS.
3. Select Sensor Tests.
4. Select Media Path2.
5. Select Diverter gate.
Open the finisher front door.
Move the lower media guide assembly to the right.
Insert a sheet of white media beneath the media
diverter gate. Then push the media to the sensor
(diverter gate).
Does the operator panel display change each time a
piece of media is placed at the front of the sensor
(diverter gate)?
Go to step 7. Go to step 6.
6 Check the sensor (diverter gate) connection.
Is the above sensor connected properly?
Replace the
sensor (diverter
gate). Go to
“Sensor
(diverter gate)
removal” on
page 4-110.
After
reconnecting, go
to step 7.
7 Check the sensor (buffer path) for correct operation.
Perform the sensor (buffer path) test.
1. Enter Diagnostics mode.
2. Select FINISHER TESTS.
3. Select Sensor Tests.
4. Select Media Path1.
5. Select Buffer path.
Open the finisher front door.
Lower the buffer pinch guide assembly.
Push a sheet of media into the buffer path and around
the buffer roll assembly in a clockwise direction.
Does the display on the operator panel change every
time the actuator of the sensor (buffer path) is
operated?
Go to step 9. Go to step 8.
8 Check the sensor (buffer path) connection.
Is the above sensor connect properly?
Replace the
sensor (buffer
path). Go to
“Sensor (buffer
path) removal”
on page 4-93.
After
reconnecting, go
to step 9.
9 Check the drive motor (buffer/transport) by opening the
finisher front door assembly and then closing it.
Does the drive motor (buffer/transport) rotate
normally?
Go to step 11. Go to step 10.
Step Check Yes No
To Next Page
Loading...
