Diagnostic information 2-27
4024-XXX
8 Check the sensor (buffer path) connection.
Is the above sensor connect properly?
Replace the
sensor (buffer
path). Go to
“Sensor (buffer
path) removal”
on page 4-93.
After
reconnecting, go
to step 9.
9 Check the drive motor (buffer/transport) by opening the
finisher front door assembly and then closing it.
Does the drive motor (buffer/transport) rotate
normally?
Go to step 11. Go to step 10.
10 Check the drive motor (buffer/transport) connection.
Is the above motor connected properly?
Replace the drive
motor (buffer/
transport). Go to
“Drive motor
(buffer/
transport) and
belt (buffer/
transport)
removal” on
page 4-115.
Problem solved.
11 Perform a test print.
Does the error still occur?
Replace the
bridge unit
interface card
assembly. Go to
“Bridge unit
interface card
assembly
removal” on
page 4-117.
Go to step 12.
Problem solved.
12 Perform a test print.
Does the error still occur?
Replace the
finisher controller
card assembly.
Go to “Finisher
controller card
assembly
removal” on
page 4-118.
Problem solved.
Step Check Yes No
To Next Page
Loading...
