2-68 Service Manual
7541-03x
Load Manual <size> If paper loaded is in the manual feeder, the job continues. If paper is not in the feeder,
pressing Select indicates to the printer it should search for a source with the proper size.
Additional messages may include:
• More information—the printer will present instructions.
• Cancel Job—the printer job can be cancelled.
Load Manual <type>
<size>
If paper loaded is in the manual feeder, the job continues. If paper is not in the feeder,
pressing Select indicates to the printer it should search for a source with the proper type and
size.
Additional messages may include:
• More information—the printer will present instructions.
• Cancel Job—the printer job can be cancelled.
Paper Changes Needed This message appears at the beginning of a parkable job. A load paper prompt will appear.
Additional messages may include:
• Prompt for each change
• Use current supplies - This is the default. The message will not appear during the
remainder of the job.
•Cancel job
• Wait for supplies - This occurs if the job is parked.
Remove All Color
Supplies
If Color Lockout mode is enabled, this message appears (unless the printer is in Diagnostics
Menu or Configuration Menu).
Remove Paper
Standard Bin
The standard output bin is full. Remove the media to continue.
bins>
Remove the paper from all output bins.
Restore Held Jobs
Go/Stop?
If the printer detects Print and Hold (or parked) jobs stored on the hard disk during Power-On
Self Test (POST). Choices are:
• Restore—Print jobs are restored, and Restoring Held Jobs x/y, where x is the number
of the job restored and y is the total number of jobs to restore. You can quit restoring, and
the remainder of the jobs will remain on the disk, but cannot be accessed until they are
restored at the next POR.
• Do not restore—Held jobs will remain on the disk, but cannot be accessed until they are
restored at the next POR. Held jobs may not be restored appears.
• Tell me more—additional information is available
Supply Needed A supply is needed to complete a job. Additional messages may include:
• Prompt for supplies
•Cancel
• Wait for supplies
Unsupported USB
device, Please Remove
Remove the unrecognized device to continue.
Unsupported Mode Unplug camera and change it to a mode where the camera can access PictBridge. Plug the
camera back in to continue.
Unsupported Disk Remove the unsupported disk to continue.
Paper Size Unsupported Make sure the paper is the correct size. Also check the tray guides to ensure they are in the
correct position. Check the paper size sensors to ensure they are in the correct position.
Securely Clearing Disk
Space
Disk wiping process is recovering disk space. The message clears when all memory blocks
are cleared.
Error code Action
To Next Page
Loading...
