Diagnostic information 2-39
7541-03x
9xx error codes Action
941.01 SDRAM R/W error See “941.01 SDRAM R/W error” on page 2-62
900.xx Unrecoverable RIP
software error / illegal trap
See “900.xx System software error” on page 2-60.
910.xx Unrecoverable engine
firmware error
Turn off printer for 10 seconds and restart. If error re-occurs, replace RIP
board.
941.02 MDC error See “941.02 MDC error” on page 2-62.
941.03 CPU error See “941.03 CPU error” on page 2-63
941.04 Abnormal MDC controller See “941.04 MDC controller error” on page 2-63
941.05 Abnormal EEPROM See “941.05 EEPROM error” on page 2-63
950.xx Service NCVRAM
Mismatch
Note: A new controller board or
operator panel has been
installed, and has not been
properly prepared for this use.
Install a new note. Do not install
both the controller board and the
operator panel at the same time
without a POR in between.
See “950.00–950.29—EPROM mismatch failure” on page 2-64.
952.xx Service NV Failure Perform a POR to clear the error.
953.xx Service NVRAM Failure Replace the RIP board. For the 958 error, replace the UICC card if
replacing the RIP board does not fix the problem.
954.xx Service NVRAM Failure
955.00 Service Code CRC <loc>
956.xx Service System Board
957.xx Service System Board
958.xx Service NAND Failure
959,xx Service Invalid Firmware Call the second level support to get the correct level of firmware and
update the firmware, or replace the RIP board.
960.xx Service Memory Error Replace the RIP board.
961.xx Service Memory Error Replace the memory in the DIMM slot.
964.xx Service Emulation Error Disable the Download Emulation. Program the download emulation into
the firmware card again. If this does not resolve the problem, then
replace the firmware card and download the emulation again.
975.xx Standard network or
Network Card X
Call your second level support.
976.xx Standard network or
Network Card X
982.xx Service <device>
990.xx Service <device>
991.xx Service <device> Card
To Next Page
Loading...
