Diagnostic aids 3-9
7541-03x
Configuration Menu
The Configuration menu contains a set of menus, settings, and operations which are infrequently used by a
user. Generally, the options made available in this menu are used to configure a printer for operation.
An asterisk (*) in the value list in the following menus indicates the default value.
Entering Config Menu
To enter the Configuration Menu:
1. Turn off the printer.
2. Press and hold 2 and 6.
3. Turn on the printer.
4. Hold the buttons until the splash screen appears.
The following are available from the Configuration Menu:
Configuration Menu
Reset Separator Roll and Pick Assembly
Counter
See “Reset Separator Roll and Pick Assembly Counter”
on page 3-10.
Reset Fuser Counter See “Reset Fuser Counter” on page 3-10.
Reset Maintenance Counter See “Reset Maintenance Counter” on page 3-10
Reset Transfer Belt Counter See “Reset Transfer Belt Counter” on page 3-11.
USB Scan To Local See “USB Scan to Local” on page 3-11.
Black Only Mode See “Reset Maintenance Counter” on page 3-10
Print Quality Pages See “Print Quality Pages” on page 3-11
Fuser Speed See “Fuser Speed” on page 3-11.
Reports See “Reports” on page 3-11
Color Trapping See “Color Trapping” on page 3-11
Tray Insert Message See “Tray Insert Message” on page 3-12.
SIZE SENSING See “SIZE SENSING” on page 3-12
Panel Menus See “Panel Menus” on page 3-12
PPDS Emulation See “PPDS Emulation” on page 3-12
Download Emuls See “Download Emuls” on page 3-12
Factory Defaults See “Factory Defaults” on page 3-12
Energy Conserve See “Energy Conserve” on page 3-13
Fax Low Power Support See “Fax Low Power Support” on page 3-13.
Min Copy Memory See “Min Copy Memory” on page 3-13.
Num Pad Job Assist See “NumPad Job Assist” on page 3-13.
Format Fax Storage See “Format Fax Storage” on page 3-13.
Fax Storage Location See “Fax Storage Location” on page 3-13.
To Next Page
Loading...
