Preventive maintenance 6-1
7541-03x
6. Preventive maintenance
This chapter describes procedures for printer preventive maintenance. Follow these recommendations to help
prevent problems and maintain optimum performance.
Safety inspection guide
The purpose of this inspection guide is to aid you in identifying unsafe conditions.
If any unsafe conditions exist, find out how serious the hazard could be and if you can continue before you
correct the hazard.
Check the following items:
• Damaged, missing, or altered parts, especially in the area of the On/Off switch and the power supply
• Damaged, missing, or altered covers, especially in the area of the top cover and the power supply cover
• Possible safety exposure from any non-Lexmark attachments
Lubrication specifications
Lubricate only when parts are replaced or as needed, not on a scheduled basis. Use of lubricants other than
those specified can cause premature failure. Some unauthorized lubricants may chemically attack
polycarbonate parts. Use IBM no. 10 oil, P/N 1280443 (Approved equivalents: Mobil DTE27, Shell Tellus 100,
Fuchs Renolin MR30), IBM no. 23 grease (Approved equivalent Shell Darina 1), and grease, P/N 99A0394 to
lubricate appropriate areas. Use Nyogel type 774 to lubricate the Fuser Drive Assembly and Nyogel 744 to
lubricate the ITU and Cartridge Drive assemblies.
Scheduled maintenance
The following parts are used for regular maintenance on the X925:
40X6372 - 300,000 page paper feed maintenance kit
40X6457 - 100,000 page MPF maintenance kit
40X6328 - ADF separator roll - Every 100,000 pages
40X6327 - ADF pick roll - Every 200,000 pages
40X6011 -Transfer belt kit w/transfer roll - Every 100,000 pages
40X6012 - Transfer roll - Every 100,000 pages
40X6013 (110V), 40X6093 (220V) - Fuser - Every 120,000 pages
40X6432 - Flatbed cushion - as needed
To Next Page
Loading...
