4-120 Service Manual
7541-03x
UICC removal
1. Remove the upper operator panel top cover. See “Op panel top cover” on page 4-13.
2. Disconnect the haptics cable (A) from the UICC.
3. Remove the UICC cable (B) from the UICC.
4. Disconnect the ribbon cable (C) from the UICC.
5. Remove the four screws (D) securing the UICC to the upper operator panel assembly.
Note: When reattaching the UICC cable to the display and the UICC card,ensure that the end of the cable with
the black tape to the display.
To Next Page
Loading...
