Lexmark X925 - Media Damage (Using ADF)

Diagnostic information 2-15
7541-03x
Media damage (using ADF)
Step Check Yes No
1 Properly load document into the ADF unit assembly and
ensure all guides are set correctly.
Re-print the defective image.
Does the error continue?
Go to step 2. Problem solved.
2
Check for obstructions in the area of the media feed
path in the ADF.
Is the media feed path free from any obstructions?
Go to step 3. Remove
obstructions.
3
Is the ADF left cover assembly properly and evenly
closed?
Go to step 4. Open then
properly close
the ADF left
cover assembly.
4
Check the ADF/pick roll assembly for damage and
wear.
Is the ADF feed/pick roll assembly free from
damage and wear?
Go to step 5. Replace the ADF
feed/pick roll
assembly.
Go to “ADF pick
roll removal” on
page 4-114.
5
Check the ADF separator roll.
Is the separator roll free from damage and wear?
Go to step 6. Replace the
separator roll.
Go to “ADF
separator roll
removal” on
page 4-115.
6
Check the ADF controller card assembly.
Replace the ADF relay board assembly.
Go to “ADF relay board” on page 4-122.
Perform a print test using the ADF.
Does the error continue?
Replace the RIP
board.
Go to “RIP
board removal”
on page 4-73.
Problem solved.