2-40 Service Manual
7541-03x
8xx scanner error
codes
Description Action
840.01 The scanner has been
manually disabled
Enter the configuration mode to re-
enable the scanner.
840.02 The scanner has
automatically been disabled
by the controller
Enter the configuration mode to re-
enable the scanner.
840.03 Scanner cable unplugged Check the scanner cables for proper
connection to the scanner and RIP
board.
841.00 Invalid configuration or ASIC
not found.
See “841.00 Invalid configuration or
ASIC not found” on page 2-56.
841.01 Invalid AFE setting. See “841.01 Invalid AFE setting” on
page 2-56.
841.02 Delayed interrupt detected. See “841.02 Delayed interrupt
detected” on page 2-57.
841.03 Failed indirect register test. See “841.03 Failed indirect register
test” on page 2-57.
841.04 Failed external DRAM test. See “841.04 Failed external DRAM
test” on page 2-57.
841.05 Image pipe timeout See “841.05 Image pipe time-out” on
page 2-57
841.06 Scanner did not initiate scan. See “841.06 Scanner did not initiate
scan” on page 2-58
842.00 No response See “842.00 No response / 842.01 HW
protocol / 842.02 Logical protocol” on
page 2-58.
842.01 HW Protocol See “842.00 No response / 842.01 HW
protocol / 842.02 Logical protocol” on
page 2-58.
842.02 Logical protocol See “842.00 No response / 842.01 HW
protocol / 842.02 Logical protocol” on
page 2-58.
843.00 Carriage home See “843.00 Carriage Home” on
page 2-59.
844.00 Lamp failure “844.00 Lamp failure (Front side)” on
page 2-59.
849.01 Machine has an installed
modem that should not be
present.
Uninstall the modem. See “849.01
Device had modem installed, but
config ID indicates it should not” on
page 2-59.
849.10 Machine has an installed
hard drive that should not be
present.
Uninstall the hard drive. See “849.10
Device had HD installed, but config ID
indicates it should not” on page 2-59.
To Next Page
Loading...
