2-72 Service Manual
7541-03x
56 USB Port <x>
Disabled
• Select Continue to clear the message.
The printer discards any data received through the USB port.
• Make sure the USB Buffer menu item is not set to Disabled.
• If this does not fix the problem, replace the PCI card.
56 Standard USB Port
Disabled
• Select Continue to clear the message.
The printer discards any data received through the USB port.
• Make sure the USB Buffer menu item is not set to Disabled.
• If this does not fix the problem, replace the RIP board. See “RIP board removal” on
page 4-73.
57 Configuration
Change
Held Jobs May Not
Be Restored
See Configuration
Change, above - not in
IR as 57
Configuration changes may be:
• Code version changes
• Paper handling options removed
• The disk was installed from a different model or speed of printer.
58 Too Many Flash
Options
Too many flash options are installed. To continue:
1. Turn off and unplug the printer.
2. Remove the excess flash memory.
3. Plug in the printer, and turn it on.
If this does not fix the problem, replace the If this does not fix the problem, replace the RIP
board. See
“RIP board removal” on page 4-73.
58 Too Many Trays
Attached
1. Turn off and unplug the printer.
2. Remove options until the supported number of options for that model. Models C925
supports three additional trays.
3. Plug in the printer, and turn it on.
61 Defective Disk • Select Continue to clear the message and continue printing.
• Install a different hard disk before performing any operations that require a hard disk.
• If this does not fix the problem, replace the RIP board. See “RIP board removal” on
page 4-73.
62 Disk full • Select Continue to clear the message and continue processing.
• Any information not previously stored on the hard disk is deleted.
• Delete fonts, macros, and other data stored on the hard disk.
• Install a larger hard disk.
• If this does not fix the problem, replace the RIP board. See “RIP board removal” on
page 4-73.
63 Unformatted disk • Select Continue to clear the message and continue printing.
• Format the disk.
• If the error message remains, replace the hard disk.
• If this does not fix the problem, replace the RIP board. See “RIP board removal” on
page 4-73.
64 Unsupported disk
format
• Select Continue to clear the message and continue printing.
• Format the disk.
• If the error message remains, replace the hard disk.
• If this does not fix the problem, replace the RIP board. See “RIP board removal” on
page 4-73.
Error code Action
To Next Page
Loading...
