4. Parameters
4-19
4.1.7 External Output Contact Signal Display [St-15]
You can check whether the ON/OFF status of digital input/output signals that access the
servo drive are on or off.
(1) External Output Signal Display
The positions of the seven segment LEDs and CN1 connector pins correspond as follows.
If an LED that corresponds to a pin is turned on/off, it indicates ON/OFF accordingly.
Output Contact Display
Number (5) (4) (3) (2) (1)
Contact
Number
DO5 DO4 DO3 DO2 DO1
CN1
pin number
45 44 43 40/41 38/39
Allocated default
signal name
INPOS BRAKE ZSPD READY ALARM
To Next Page
Loading...