7-6 (E)
7. Operation Method
LH71A / LH72
5 Use the key to finalize the setting.
(The value 20 is stored as the value of the machining datum
point in No. 0.)
6 Press the key.
Editing is completed, and the current value is displayed.
( lamp goes out)
∗ When using an edited machining datum point, carry out <Set-
ting of machining datum point>.
ABS indication remains on during datum point mode.
The machining datum point (No. 0) is based on linear compensation.
(Position of datum point value 0 = Correction amount 0)
To Next Page
Loading...
