Micromeritics ACCUPYC II 1345 User Manual

1 About the AccuPyc II
Acomputer is not required if the keypad/display is used. When used in this configuration, data can
be sent to a USB equipped printer.
Operating System
Windows 7 Professional or higher operating system is recom-
mended for the best user experience. For 21 CFR Part 11 envir-
onments, Windows 10 Professional or Windows 10 Enterprise or
higher is required.
Desktop Installation
Required
The application should not be installed on a network drive with
shared access. Multiple users cannot operate the application at the
same time.
10 Base T or 100 Base T
Ethernet Port
If the computer is to be connected to a network, two Ethernet ports
are required. If more than one Ethernet based unit is connected to
the same computer (or if a SmartVacPrep is purchased), an Eth-
ernet switch will also be required.
Read/Write Permissions
All users of the application will need Read/Write permission to all dir-
ectories and subdirectories where the application is installed. For 21
CFR Part 11 environments, permission may be limited to the install-
ation directory.
Drives USBport
Computer Requirements
Due to continuous improvements, specifications are subject to change without notice.
1 - 14
AccuPyc II 1345 Operator Manual
134-42851-01 (Rev A) — Jan 2021

Micromeritics ACCUPYC II 1345 Specifications

General

Brand	Micromeritics
Model	ACCUPYC II 1345
Category	Measuring Instruments
Language	English