Microsemi SyncServer S650 - Page 255

098-00720-000 Revision D1 – February, 2018 SyncServer 600 Series User’s Guide 255
Appendix A System Messages
System Notification Messages
Input ref poor
quality
21 Minor No GNSS | NTP | J1A | J2A |
J2A | J2B
Input Poor Quality
GNSS | NTP | J1A | J2A |
J2A | J2B
Input poor quality cleared
 If this persists for
> 1hr check input
reference.
 For GNSS check
signal quality.
No action required
Channel Time
Qualified
22 Notify No GNSS input time
qualified
exit GNSS input time
qualified
No action required
No action required
Time input selected 24 Notify Yes GNSS | NTP | J1A | J2A |
J2A | J2B
input selected as time
reference
No action required
Freq input selected 25 Notify Yes GNSS | NTP | J1A | J2A |
J2A | J2B
input selected as
frequency reference
No action required
GNSS Time
Qualified
33 Notify No GNSS input time qualified
Exit Input Time qualified
cleared
No action required
No action required
NTP Time Qualified 34 Notify No NTP input time qualified
Exit NTP Input Time
qualified cleared
No action required
No action required
PTP Time Qualified 35 Notify No PTP input time qualified
Exit PTP input time
qualified
No action required
No action required
Table A-1. System Notification Messages (Continued)
Description
Event
ID
Msg
Level
Trans-
itory
MsgText Corrective Action