Midas HD96-24-CC-TP

135 HD96-24-CC-TP User Manual
ADT
PRE-DELAY control adjusts the delay time before the second voice is heard. Delay is adjustable within the range 0 to 127ms.
PATTERN control selects the number and spacing of the second voices. Selection is from Pattern 1 (two voices) to Pattern 5 (eight voices).
REV button mutes the eect.
Preset parameters: On selecting this eect program, delay is set to 40ms and pattern is Pattern 5 (a wide multi-voiced eect).
Stereo mix: Left and right output signal’s use dierent delay taps to achieve a stereo eect. Using only one output halves the number of ‘voices’, that is, Pattern 1
(one voice) to Pattern 5 (four voices).
Application Notes:
1. Try delays from 25 to 50ms. Short delays reduce the eect, long delays produce echo.
2. Direct signal must be added at a suitable level on the mixing console. Try 50/50 direct/eect mix on Pattern 1, much less direct on Pattern 5.
3. For conventional ADT, try ‘Delay’ of 40ms, Pattern 1, and use one output only, panned, say, fully right. Pan direct signal fully left and use a 50/50 direct/eect mix.
Multi-Tap Echo
PRE-DELAY control adjusts the time delay interval between the direct signal and the rst repeat. Delay is adjustable from 0 to 990ms.
PATTERN control selects the number and spacing of the repeats. Pattern 1 (two repeats) to Pattern 9 (eight repeats).
DECAY control sets the feedback (regeneration) level for repeat echoes.
HF control allows the high frequency ltering to be applied to the regenerated signal.
REV button mutes the eect.
Preset parameters: On selecting this eect program: delay is set to 196ms; pattern is Pattern 4; decay is 73; and HF is 0. These settings give an eect similar to a
typical multi-head tape echo, but with full stereo image.
Stereo mix: Dierent delay taps are used for left and right outputs to achieve a stereo eect. Using only one output halves the number of taps, that is, Pattern 1 (one
tap), Pattern 9 (four taps).
Application Notes:
1. Set delay time as required, generally fairly short for multi-echoes (higher pattern numbers), and longer for repeat echo. ‘Fine tune’ delay setting to set exact
musical timing for single tap repeat echoes.
2. Direct signal must be added at a suitable level on the mixing console.
3. For single tap repeat echo, start with Pattern 1, with ‘Delay’, ‘HF’ and ‘Decay’ all set at maximum. Reduce parameters as required. Use one output only.
Sound-On-Sound
PRE-DELAY control sets the ‘loop length’ and hence the timing of the eect between 0 and 2.0 seconds.
LEVEL control provides 10 level increments of signal input to the ‘digital loop’. Return level to ‘0’ after use to avoid noise build-up.
DECAY control sets the ‘erasure’ of the loop from ‘0’ (100% erasure) to ‘99’ (zero erasure).
REV button clears the memory of unwanted eect.
Preset parameters: On selecting this eect program: pre-delay is set to 2.0s; level is 0; and decay is 99. These settings represent maximum loop length with zero
erasure. Please note that no sound will be heard until ‘level’ is increased.
Stereo mix: Outputs left, and right are essentially identical. However, to avoid the possibility of slight phase cancellations, it is recommended that only one output is
used on this program.