279 HD96-24-CC-TP User Manual
Processing Order
Similarly, to the input channels, you can change the processing order on all of the output channels. Hold and drag to reorder the processing blocks. The Insert point can
only be moved post fader as shown below.
Mixes
Each of the aux and master output channels can send a variable contribution to each of the matrices. The busses are controlled via fader or assignable controls that
give continuous adjustment (in the range +6 dB to ∞) of subgroup levels sent to matrix mixes. The mixes on the outputs are similar in functionality to inputs, except
there is no after fader listen. For details, see “Mixes” in chapter 29.
Masters
For each output, the masters section functions in the same way as for the inputs (see “Master section and pan control”, “Surface/GUI mute and solo ” and “Fader” in
chapter 29).
Outputs Management Macro Control
The Output management page found in the Home workow can be used in two ways:
Path Select Control
Select the path you wish to change the select the parameter (Solo, Mute, Fader Level, Group mode and Talk). Fader level can be changed in 1 of 3 modes: Absolute,
Relative or Pass-thru.
To select a path and change fader level:
1. Press the path or paths you wish to select or press and hold to select all paths on current page (as shown below). Pressing individual selected paths again will
de-select them.
2. Adjust fader level.
3. Change mode if required (Absolute, Relative or Pass-thru).
TIP: This is a great place to quickly set all your aux paths to 0 dB, send pink noise to multiple paths or to mute all auxes/matrices quickly if needed.
To Next Page
Loading...
Need help?
General
