Milestone Srl MA245-003 – ultraWAVE 3 – User Manual
13
Maintenance after each run
• The base load must be replaced every run and the PTFE vessels must be removed from the
cavity.
• Dry very well the steel cavity (inside and outside) and the clamps. Clean them using Ethanol.
• Before turning off the unit, it is recommended to grease all the steel part of the reactor using a
small amount of oil or grease provided with the unit.
More detailed information concerning the operating steps and the maintenance can be found into the
next chapters of ultraWAVE 3 user manual.
To Next Page
Loading...
