Milestone Srl MA245-001 – ultraWAVE 3 – User Manual
132
Program
You have already executed a microwave application
without storing these data.
Do you want to ignore the recordings and start a new
program ?
You have not saved the program file. During a restart, all
unsaved data of the last run will be lost.
The program file can be stored in the sequence register.
The program time of all segments is zero. Please specify
a valid program or select a predefined method.
You have not yet defined a program. In the register
method \ program allows you to create a program or
load from disk (see Chapter program).
Your microwave program is longer than 2 hours.
Is it correct ?
In all applications, an examination of the length of the
program takes place. With a length of more than 2 hours,
this prompt appears. The program is not limited to 2
hours.
You have already run a microwave program without
saving the data.
By leaving this page, all the data will be lost.
Would you really want to exit this page?
You have not saved the program file. When you exit the
application pages all unsaved data of the last run will be
lost.
The program file can be stored in the sequence register.
You have already executed a microwave application
without storing these data. Do you want to ignore the
recordings and load an old graphic file ?
The method and sample table are stored with the
program file. When loading a sequence, the current
method, sample table and chart the course will be
overwritten.
You have made changes on your sample table.
If you load an old sample table your modifications will be
lost.
Do you want to ignore these modifications and load an
old sample table ?
When loading a sample table, the current sample table is
overwritten
With this command all lines of your sample table will be
deleted.
Do you really want to delete all samples ?
Confirmation request before deleting a modified sample
table from memory.
Internal memory, disks and signature
The internal memory is filled to over 90%. There is still
enough available space for the recording.
The internal memory is almost full.
The administrator should truncate the log. After
shortening still remain 100 entries.
To Next Page
Loading...
