Milestone Srl MA245-003 – ultraWAVE 3 – User Manual
18
3 SAFETY RULES
General Information
• Carefully read this operator manual before starting the system and follow its prescriptions with the
utmost care.
• In case the system has been delivered with additional accessories, also carefully read the
instruction manuals of such accessories.
• Follow particularly the recommended instructions for Service and Maintenance.
• This Operator Manual is part of the delivery, hence must be always kept together with the
instrument on its working place.
• It is imperative that every person operating this system has read and fully understood this manual.
• The non-observance of the instructions contained herein, or improper use may involve
damages/injuries that are not covered by product liability!
• The ruling national and international safety norms in working environment shall in any case be
observed under user’s responsibility.
• It is also user’s responsibility to keep constantly updated all safety norms ruling in the country or
operation.
Safety Rules for Start-up
First start-up of the system must exclusively be carried out by authorized and trained service / application
engineers appointed by Milestone.
Safety in operation
• Pressure vessel may only be opened once the user has made sure – by looking at the operating
pressure display in front of the unit – that there is no more pressure inside. The pressure sensor
alone has not to be considered as a sufficient safety device.
• The ultraWAVE 3 must exclusively be operated for its intended use.
• The unit must only be operated within the power limits set forth by the technical specifications.
• The unit must be operated exclusively by specially trained people.
• All electrical parts must always be protected from wet and humidity.
• The unit must be kept clean.
• The unit must be operated only for applications released and recommended by MLS-Milestone.
• Basic rules of chemistry will always apply. The basic rules of chemistry are valid also for handling
chemicals in this unit. Working with chemicals always takes all those safety measures that are
usually required (e.g. lab coat, protective gloves, protective glasses mask, exhausts hood, etc.)
Safety in Service Operation
• In case of failure or damage of the unit, the intervention of an authorized and trained service
operator must be requested. The unit shall not be used until successful repair is completed.
• The unit includes components in which pressures up to 200 bars can be reached.
• The unit includes components in which lethal high voltage of 4kV can be reached.
To Next Page
Loading...
