EasyManua.ls Logo

Minebea CSD-709 - Replacing the Fuse

Default Icon
218 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9 Troubleshooting
114
9.3 Replacing the fuse
The fuse is mounted on the printed board. Described below are replacement procedures for the fuse.
1. Turn off the CSD-709.
2. Remove the two screws (A) from the rear panel and detach the top plate (B).
3. Replace the fuse (A) mounted on the printed board with a new one.
CAUTION
Problems will occur if the fuse is incorrectly mounted or its capacity is insufficient.
4. Reinstall the top plate and fix it with the two screws.

Table of Contents

Other manuals for Minebea CSD-709

Related product manuals