Minebea CSD-709 User Manual

2 Installation and Wiring
20
2.2 Wiring
WARNING
 Turn off power before connecting or disconnecting cables. The CSD-709 is not
equipped with a power switch. When you conduct work with the CSD-709 turned on,
electric shock or equipment damage may result.
 Before turning on power, check to confirm that the power supply voltage indicated
on the CSD-709 and in the specifications agrees with the voltage actually supplied.
Using an unconfirmed power supply may result in electric shock or equipment
damage.
CAUTION
 The connector board on the rear panel of the CSD-709 is a resin component. Do not
drop it or subject it to strong impact.
 Always use shielded cables, except for power cables. Separate cables from noise
sources, including power cables of peripheral devices and control I/O.
 In the conduit, arrange cables only for the CSD-709. Avoid joint use with other lines
in the conduit.
 Ground the CSD-709 based on Type D single grounding using a protective ground
connector. Also, do not use the grounding line of the CSD-709 to ground the power
supply system.

Minebea CSD-709 Specifications

General

Brand	Minebea
Model	CSD-709
Category	Measuring Instruments
Language	English