Minebea CSD-709 - D Detection Operation and Section; Detection Operation

D Detection Operation and Section
145
D
Detection Operation and Section
D.1 Detection operation
The CSD-709 uses the following detection operations to hold the loads.
 Peak hold
 Bottom hold
 Peak-bottom hold
 Peak-to-peak hold
 Maximum hold
 Minimum hold
 Maximum-minimum difference hold
 Inflection point hold
 Average
D.1.1 Peak hold
In the peak hold mode, the load measured immediately before is compared to the current load and,
when [load measured immediately before ≤ current load] is established, the current load is held as a
peak.
A (held as peak)