4 Settings Related to Measurement
58
4.4 Enabling the analog peak detection circuit
To avoid the delay induced by the digital processing of inputs from the measuring unit, the analog
peak detection circuit should be enabled. You can enable or disable the analog peak detection circuit
with function F-12. Described below are the procedures used to enable the analog peak detection
circuit.
1. Press once to display .
2. Press .
The Function mode is activated, and the display changes to a two-digit numerical value prefixed
with [F-].
3. Using and , change the numerical value to and press .
The number showing the current status of the analog peak detection circuit appears.
Number Status of analog peak detection circuit
0
Disable
1 Enable
0 (Disable)
For setting procedures with and , see Section 1.6, "Basic key operation".
4. To enable the analog peak detection circuit, press to change the display to [1].
5. Press .
6. Press twice to return to Measurement mode.
Default
[F-12]
To Next Page
Loading...
Need help?
General
