Revision History
5
Date Manual No. Revision reason (details)
2019/03 DRW. No. EN294-1742D
Due to ECN No.FN19-0159
8-1. Correction
The following statement is added to the note of the
external control input.
･Do not assign the same set value to multiple PIN
numbers.This instrument does not work properly.
2019/07 DRW. No. EN294-1742E
Due to ECN No.FN19-0199
7.7 Printing with serial interface -> Print command through
serial interface.
8.1 External control input signal
Designate print command (only when the serial interface
card is mounted. -> print command (through serial
interface), Print command synchronization mode.
Add the explanation in [POINT] column
・Refer the [10.3 Data format] for Print command
synchronization mode.
Designate print command (only when the serial interface
card is mounted. -> print command (through serial
interface), Print command synchronization mode.
A.4.1 External input signal
Print command (serial interface) -> Print command (serial
interface), Print command synchronization mode
J.4 Calibration based on Modbus
Address -> Data, Data -> Address
K.3 Setting, K4 Checking on Problems
Printing with serial interface -> Print command through
serial interface,
Print signal synchronization→Print command
synchronization.
Function setting table
F-30, F-37 Print signal synchronization -> Print command
synchronization
F-55 4 (Printing with serial interface) -> (Print command
through serial interface)
Due to ECN No.FN19-0446
A.11.10 correct the unit from [bps] to [kbps].
To Next Page
Loading...
