Chapter 4 System Setup
42 Lynx II DSA User's Manual - 7096089
If the Discover button is selected and the Universal Plug and Play features have been
enabled (see note below), the Lynx II identification information will be displayed. Select
the desired Lynx II and click the OK button to automatically fill the IP address
information in the Device IP Address field.
Note: Discover will only work on networks that do not block Universal Plug and Play
(UPnP) messages and the PC must have UPnP enabled. UPnP in the Lynx II is
enabled by default.
Figure 19 MID Plug and Play Discover of Lynx II
To Next Page
Loading...
Need help?
General
