Mitel 6930 - Configuring Call Forward Using the Mitel Web UI

174
M
ANAGING CALLS DND AND CALL FORWARD
Configuring Call Forward Using the Mitel Web UI
1. Click on Basic Settings >Preferences > General.
2. In the Call Forward Key Mode field, select a call forward mode to use on the phone.
– Account (default): The Account mode allows you to configure Call Forward on a per account basis.
Pressing a configured Call Forwardkey applies to the account in focus.
– Phone: The Phone mode allows you to set the same Call Forward configuration for all accounts (All,
Busy, and/or No Answer). When you configure the initial account, the phone applies the configura-
tion to all other accounts. (In the Mitel Web UI, only the account you configured is enabled. All other
accounts are greyed out but set to the same configuration.) Using the Mitel Web UI, if you make
changes to that initial account, the changes apply to all accounts on the phone.
– Custom: The Custom mode allows you to configure Call Forward for a specific account or all
accounts. You can configure a specific state (All, Busy, and/or No Answer) for each account inde-
pendently or all accounts. On the 6930, you can set all accounts to All On, All Off, or copy the
configuration for the account in focus to all other accounts using a CopytoAllsoftkey.
NOTE: If there is only one account configured on the phone, then the mode setting is ignored
and the phone behaves as if the mode was set to Phone.
3. Click Save Settings. The changes takes affect immediately without a reboot.