69
C
USTOMIZING YOUR PHONE AUDIO
To enable/disable USB Wireless headset mode:
1. Press the (Settings) key to enter the Settings menu.
2. Navigate to the Audio > Headset setting and press the Select softkey.
3. Press down navigation button to choose USB Wireless.
4. Press the right navigation key to move to enable/disable selection column.
5. Use the up and down navigation keys to choose the applicable setting.
6. Press the Save softkey to save your changes.
NOTE: Disable this setting if you are not using USB Wireless Headset.
Ring Tones and Tone Sets
There are several distinct ring tones a user can select to set on the IP phones. In addition to the 15
pre-installed ringtones, custom ring tones can be manually installed through the Web UI and selected for
use (if enabled by your Administrator). You can enable/disable these ring tones on a global or per-line
basis.
There are 10 additional ringtones are available (Velocity, Skyline, Rise, Daybreak, After Hours, Open
Road, Pronto, Voyage, Bloom, Move).
NOTE: Individual contact ring tones are also supported on the 6930. Individual contact ring tones can be
used during incoming calls to help users identify the party calling. For more information on individual
contact ring tones, see “Local Directory Features” .
The following table identifies the valid settings and default values for each type of configuration method.
Ring Tones
To Next Page
Loading...
