Motorola APEX1000 User Manual

B
Configuration • PSIP Configuration
APEX1000 All-Purpose Edge QAM Software Version 2.4.x • Installation and Operation Manual
98
573408-001-a
PSIP Configuration window field definitions
Item Definition/Range
Enable PSIP
Processing
Use this area to enable PSIP for the output transport stream. To enable a transport
stream for PSIP, select the desired line(s) and click >>>. (Only applicable to manual
route OTSs.)
IMPORTANT: PSIP processing also requires that Time Source be set to SNTP
The default is Disabled.
Note: You must click Apply to enable the transport stream.
Message
Insertion
Period (ms)
Shows the insertion rate for each PSIP table (global).
Default values are:
PSIP Table
Default Insertion
Rate
MGT – Message insertion period in milliseconds for
the PSIP Master Guide Table (MGT). This message is
sent on the PSIP Base PID before the start of
insertion of the first packet of the message.
150 ms
STT – Message insertion period in milliseconds for
the PSIP System Time Table (STT). This message is
sent on the PSIP Base PID before the start of
insertion of the first packet of the message.
1000 ms
CVCT – Message insertion period in milliseconds for
the PSIP Cable Virtual Channel Table (CVCT). This
message is sent on the PSIP Base PID before the
start of insertion of the first packet of the message.
400 ms
RRT – Message insertion period in milliseconds for
the PSIP Rating Region Table (RRT). This message is
sent on the PSIP before the start of insertion of the
first packet of the message.
60000 ms
Event Information Table – Insertion period in
milliseconds for the PSIP EIT messages.
Default Insertion
Rate
EIT-0
500 ms
EIT-1
3000 ms
EIT-2
10000 ms
EIT-3
10000 ms
DST Settings
Use this area for defining the DST values for In/Out Month, Day, and Hour.

Motorola APEX1000 Specifications

General

Brand	Motorola
Model	APEX1000
Category	Switch
Language	English