Motorola APEX1000 - Figure 3-1 - APEX1000 Rack Mounting

B
Installation • Mounting the APEX1000
APEX1000 All-Purpose Edge QAM Software Version 2.4.x • Installation and Operation Manual
32
573408-001-a
Figure 3-1 — APEX1000 rack mounting
2. Extend the two pre-attached support rails on the sides of the APEX1000 as
necessary to ensure they will pass-through their respective rear brackets when the
APEX1000 is mounted to the rack.
3. Insert the APEX1000 into the rack by sliding the side support rails through the rear
mounting brackets.
4. Secure the front of the APEX1000 to the front rack angles with the four #10 (32 x
.50-inch) long screws and plastic washers.
5. Tighten all screws.