Motorola APEX1000 - Mapping Error Log; Figure 12-16 - Mapping Errors Window

B
Status • Reports
APEX1000 All-Purpose Edge QAM Software Version 2.4.x • Installation and Operation Manual
241
573408-001-a
Mapping Error Log
All Program Mappings and Ancillary PID Remapping errors are registered in the Mapping
Errors log window:
Figure 12-16 — Mapping Errors window
Mapping Errors window field definitions
Item Definition
Time Logged
Displays the date, time, and the time zone that the error was logged.
Error Code
Displays a numerical value error code that corresponds to the fault condition. See Mapping
Error Codes for a complete listing of possible error conditions.
Mapping Type
Displays the mapping type. Types: Program, Ancillary PID
TS:QAM
The Output Transport Stream numbers (1 – 16, 17 – 32, 33 – 48) and Output QAM
channel.
Input
Number of the input type from which to obtain data (GigE 1 – 4 or Host 1 – 2).
Multicast
The Multicast receive IP address:
• Valid Range: 224.0.1.0 – 239.255.255.255
• Reserved: 224.0.0.0 – 224.0.0.255
• Not used: 0.0.0.0
Source
This is the IP address of the source device for multicast reception.
Mapping
Displays the mapping range in->out.