B
Manual Routing • Input Stream Redundancy
APEX1000 All-Purpose Edge QAM Software Version 2.4.x • Installation and Operation Manual
151
573408-001-a
Window Section Definition
Threshold
Displays the user-configured redundancy threshold percentage to compare
the Primary vs. the Secondary input streams. Use this percentage to
determine if a threshold change has occurred, and if a failover to the
Secondary or fallback to the Primary is required.
The threshold is applied to the secondary input stream when compared to
the primary. A primary is determined to be below the secondary using the
threshold as follows:
Primary < (Secondary * Threshold %)
Example: A threshold percentage of 90%, means that the Primary input
stream would have to drop to less than 90% of the secondary before a
failover occurs. Assuming the secondary has an input rate of 38.81, the
primary would have to drop to a rate below 34.93% before a failover to the
secondary would occur.
Note: Only applicable when the Redundancy Type is set to
Hot/Hot.
Suspend Failover
This function becomes available only when Redund Enabled is checked.
Check this box to prevent a Primary stream from failing over to the
Secondary, even if it is Redundancy Enabled.
Help
Opens a new window that displays usage information.
Display Range
Activates an auxiliary menu from which to select and display the Index
range.
Range: 1 – 768
Note: The Apply function is set on a row basis rather than for the entire window. Apply is set only for rows
that have changed.
To Next Page
Loading...
